Lab 1 - EE 420L
Authored by Sergio Covarrubias
covars1@unlv.nevada.edu
02/02/2016
Lab description
Pre-lab work
1. Reques CMOSedo account.
- Your lab reports will be drafted using html and placed on CMOSedu.
- Prior to the first day of lab, but no earlier than one week before the lab starts, request a CMOSedu account, using your UNLV email address, from Dr. Baker (rjacobbaker@gmail.com).
- Review the material seen here covering editing webpages (do this before the first lab).
2. Review the material seen here covering editing webpages (do this before the first lab).
- Read the entire write-up seen below before coming to lab
3. Learn how to use the SNIPPING Tool
Post Lab
Review of basic RC circuits
For
this first lab simulate, and verify the simulation results with
experimental measurements, the circuits seen in Figs. 1.21, 1.22, and
1.24 (use a 1 uF cap in place of the 1 pF cap) of the book.
Your results should be similar to, but more complete than, the
simulation results seen on pages 17 - 23. In your report, and for
each circuit, show the
- Circuit schematic showing values and simulation parameters (snip the image from LTspice).
- Hand calculations to detail the circuit's operation.
- Simulation results using LTspice verifying hand calculations.
- Scope waverforms verifying simulation results and hand calculations.
- Comments on any differences or further potential testing that may be useful (don't just give the results, discuss them).
Experiment #1 figure 4.21
Experiment #2 figure 4.22
Experiment #3 figure 4.24
Return to EE 420L Labs