Lab X - ECE 421L
First, calculated by hand and bulid up the RC circuit in Figure 1.21.
the result of hand calculation as follows
a. the output voltage = Vout=Ving*[(1/jwC)/(1/jwC+R)]=622V
b. the magnitude of equation=|Vout/Vin|=[(1/(1+2*pi*f*RC)^2)]=0.622mV
c. phase of equation=-tan-(2*pi*f*RC)=-0.89radians
Discussions of Fig. 1.22:
First, calculated by hand and bulid up the RC circuit in Figure 1.22.
the tesult of hand calculations as follows
a. the magnitude of equation=|(1+jwRC1)^2/(1+jwR(C1+C2))^2|=0.61
b. the phase of equation= [-tan-(2*pi*f*RC1)-tan-(2*pi*f*R(C1+C@))]=-0.12radians
Discussions of Fig. 1.24:
First, calculated by hand and bulid up the RC circuit in Figure 1.24.
a. simulation results as forllwos
also, changing or increasing resistance can make the time delay the rising or falling time longer.
Post Lab work-1
Goal: goal of this lab is to developing our knowledge of characteristics of RC circuits and see different results with simulation and hand clalculatios.
Equipment used
a. power supply
b. wire, resistor, and capacitor
c. breadboard
d. oscilloscope
lab report fig1.21lab report fig 1.22
lab report fig 1.24
Indeed, the result have some slide different results, however by changing the values can see the effect of the circuits.